HP Designjet T1200 Printer series - Manual (Page 18)

The printer's internal prints
The internal prints give various kinds of information about your printer. They can be requested from
the front panel without using a computer.
Before requesting any internal print, check that the printer and the paper are ready for printing.
● The print will be made on the active roll. To change the active roll, select the Paper menu icon
, then Select active roll.
● The loaded paper should be at least A3 landscape—420 mm (16.53in) wide—otherwise the print
may be clipped.
● The front panel should be displaying the Ready message.
To print any internal print, select the Internal Prints menu icon , then select the internal print you
want. The following internal prints are available.
● Demo prints: show some of the capabilities of the printer
◦ Print drawing demo
◦ Print rendering demo
◦ Print GIS map
● Menu map: shows details of all the front-panel display menus
● Configuration: shows all the current front-panel display settings
● Usage report: shows estimates of the total number of prints, number of prints by paper type,
number of prints by print-quality option and total amount of ink used per color (the accuracy of
these estimates is not guaranteed) (T770 HD and T1200 series only)
● HP-GL/2 palette: shows the color or grayscale definitions in the currently selected color palette
● Service information: provides information needed by service engineers
● PostScript font list: shows PostScript fonts available (PostScript printers only)
10 Chapter 1 Introduction ENWW
Introduction