Change the graphic language setting – HP Designjet T1200 Printer series User Manual
Page 38
You have various other options available from the Connectivity menu icon.
●
USB: view information about the USB connection
●
Jetdirect EIO: view information, configure and reset the Jetdirect connection
●
Advanced > Select I/O timeout: specify the number of seconds that an idle connection is
allowed to remain open, 270 is the default value, if set to zero, the timeout is disabled
●
Advanced > Allow SNMP: specify whether SNMP is permitted
●
Advanced > Embedded Web Server > Allow EWS: specify whether the Embedded Web
Server is enabled
●
Advanced > Web Services > HP Utility software: view the HP Utility software settings
●
Advanced > Web Services > Color and paper management: view the color and paper
management settings
Change the graphic language setting
You can change the graphic language setting from the HP Utility with the following steps (T1200
series only).
1.
Under Windows, select the Settings tab then Printer settings > Printing preferences.
Under Mac OS, select Configuration then Printer settings > Configure printer settings >
Printing preferences.
2.
Select one of the following options.
●
Select Automatic to let the printer determine which type of file it is receiving. This is the
default setting; it works for most software applications. You should not normally need to
change it.
●
Select HP-GL/2 only if you are sending a file of that type directly to the printer, without
going through a printer driver.
●
Select PDF only if you are sending a file of that type directly to the printer, without going
through a printer driver (PostScript printers only).
●
Select PostScript only if you are sending a file of that type directly to the printer, without
going through a printer driver (PostScript printers only).
●
Select TIFF only if you are sending a file of that type directly to the printer, without going
through a printer driver (T1200 PS only).
●
Select JPEG only if you are sending a file of that type directly to the printer, without going
through a printer driver (T1200 PS only).
You can change the graphic language setting from the front panel. Select the Setup menu icon
,
then Printing preferences > Select graphic language. Select the desired option and press the
OK
key to set the value.
NOTE:
If the graphic language is set from the HP Utility, it overrides the front panel setting.
30
Chapter 4 Personalizing the printer
ENWW
Perso
n
al settings