HP Designjet T1200 Printer series - Manual (Page 49)

7. When prompted by the front panel, insert the sheet into the cut-sheet slot on the right side of the
printer.
Load your sheet aligned with the load line and insert until the paper will not continue; with thicker
sheets, you feel resistance.
WARNING! Do not push your fingers inside the printer's paper path.
8. Press the OK key on the front panel to feed the paper into the printer. Guide the sheet into the
printer; this is especially important with thicker papers.
9. The printer checks the alignment and measures the sheet.
NOTE: Depending on the length of the sheet, it feeds out the front of the printer.
10. If the length of the sheet is more than 600 mm (23 in), the front panel prompts you to check that
the rear of the sheet is hanging backwards over the roll cover (and not forwards over the printer
window).
11. If the sheet is not correctly aligned, you may be asked to correct the alignment. Please follow the
instructions on the front-panel display.
NOTE: If you have an unexpected problem at any stage of the paper loading process, see The
paper cannot be loaded successfully on page 136 .
Unload a single sheet
To unload a single sheet after printing, you can simply pull the sheet free from the front of the printer.
To unload a sheet without printing, use the Unload paper key (T770 series only) or the following
Paper menu procedure.
1.
At the front panel, select the Paper menu icon .
ENWW Unload a single sheet 41
P
ape
r ha
ndl
ing