HP ProLiant DL760 G2 Server - Manual (Page 273)

Troubleshooting Information
Table E-1: Diagnosis Steps continued
Question Action
Question 7: Check the Memory
Error and Processor Bus Fault
LEDs.
Are there are any amber LEDs
illuminated when viewed through
the processor air intake area of the
processor and memory module as
shown in Figure E-1?
If no, continue to Question 8
If yes, check the following:
• If memory was just added remove memory and retry
booting the system. If the system boots, memory
should be sent back to service
• If processors or a processor board was just added,
remove and retry booting the system with processor
board 1 installed only.
Figure E-1: Memory error and processor bus fault
LED location
Question 8: Did the “Memory
Configuration Error Diagnostic”
screen, as shown in Figure E-2,
appear? If no, memory configuration is adequate to boot the system.
An F1 prompt displays for “Memory Configuration Warnings”
to inform the user of memory configuration errors that
should be corrected. Refer to Table E-8.
If yes, memory configuration must be corrected to boot the
system. Refer to Table E-8.
HP ProLiant DL760 Generation 2 Server User Guide E-5
HP CONFIDENTIAL
Writer: Jennifer Hayward File Name: o-appe Troubleshooting Information.doc
Codename: Pioneer Part Number: 201264-002 Last Saved On: 6/17/03 10:42 AM