HP Netserver E Server series - Manual (Page 17)

Chapter 2 Opening and Closing the HP NetServer
11
5. If you are installing accessories or servicing the NetServer, move the feet
inward before turning it over on its right side.
Refer to "Adjusting the HP NetServer Feet." The right and left sides are
defined by facing the front of the HP NetServer.
Replacing the Cover
To replace the cover, follow these steps:
1. If you have been installing accessories or servicing the NetServer, return
the feet to the normal position before turning the NetServer upright.
Refer to "Adjusting the NetServer Feet" later in this chapter.
2. If necessary, return the air duct to its closed position.
3. Place one hand on either side of the cover and press inward lightly while
lowering the cover onto the chassis.
The cover flanges rest on the rails inside the chassis. See Figure 2-3.
Front of
Chassis
Bottom of
Chassis
Figure 2-3. Replacing the Cover