HP VMA-series Memory Arrays - Manual (Page 79)

AM456-9007B Rev 02 HP VMA SAN Gateway Installation and User Guide 79
lun set Command
The lun set command enables you to set a LUN as read-only.
The lun set command is the only command usable after a LUN has been created
except the no lun create … readonly command.
Syntax
[no] lun set container <id> name <name> readonly
show luns Command
Syntax
show luns [container <id>[ [name <id>] [count] [sessions]
[serial page80 | page83-ascii | page83-binary]
Syntax Description
show containers Command
The show containers command displays all available containers.
Syntax
show containers
blksize Defines the logical block or sector size for the
created LUNs; the default is 512, can be set to
512 or 4096. Not all systems can handle 4096-
byte sizes. Use 512 if you are in doubt. There is
another word here I can’t read.
offline Creates the LUNs in offline mode.
container The container parameter enables you to show
only the LUNs within a specific container.
name The name parameter enables you to show a
specific LUN.
sessions The session parameter shows the sessions
accessing a particular LUN.
Table 4.4 show luns Command
Table 4.3 lun create Command