HP StorageWorks 2000fc G2 Modular Smart Array - Manual (Page 36)

36 Getting started
4. Wait while the application discovers (detects) switches, servers, storage subsystems, and logical disks.
This may take a few minutes.
If the application detects a new, unconfigured switch in your SAN, the New Switch Setup dialog box
( Figure 12 ) opens.
Figure 12 New Switch Setup dialog box
The New Switch Setup dialog box prompts you to set up the new switch by completing these three
steps:
1. Set switch IP address
2. Set switch administrator password
3. Set switch zoning: HBA zoning
5. Choose one of the following options:
• To continue with the first step (setting the switch IP address), click OK. The Set Switch IP Address
dialog box ( Figure 13 ) opens. Go to step 6 .
• To skip the switch setup for now, click Cancel. (To set up the switch later, see the procedures in
“Managing switches” on page 49. If you do not complete switch set up before you exit Simple SAN
Connection Manager, the New Switch Setup dialog box will open again the next time you start the
application.)
The Set Switch IP Address dialog box ( Figure 13 ) shows the switch name and default IP address.