HP IO Accelerator for BladeSystem c-Class - Manual (Page 84)

Index 84
manual installation on Windows Server 21
monitoring IO Accelerator health 54
N
naming 27
NAND flash and component failure 54
non-paged memory pool 61
NUMA architecture 67
NUMA configuration 67, 68
O
operating environment 9
outdated firmware 26
overview 7
P
page files, setting up 62
PCIe power override, enabling 38
PCIe power, enabling 27
performance and tuning 65
performance and tuning, introduction 65
performance attributes 8
performing a multi-disk configuration 28
phone numbers 71
R
RAID configuration 29
RAM consumption for page files 60
regulatory compliance identification numbers 79
regulatory compliance notices 79
required information 71
resources 70, 71
S
series number 79
setting interrupt handler affinity 66
setting NUMA affinity 66
setting up SNMP 29
setup wizard, using 14
silent installation 26
SNMP MIB support 31
SNMP, Windows details 29
software installation 13
software RAID and health monitoring 55
starting Trim 58
stopping Trim 58
support 71
supported firmware revisions 9
supported hardware 9
system drive paging file configuration 63
system log errors 69
T
Taiwan battery recycling notice 79
technical support 71
telephone numbers 71
Trim configurations 59
Trim support 57
Trim, introduction 57
Trim, platforms 57
troubleshooting 35
U
uninstalling a previously-installed drive 12
uninstalling the driver 37
unmanaged shutdown issues 38
upgrade procedures 23
upgrading driver software 24, 25
upgrading firmware 19, 20, 23
using installation logs 33
using test mode registry values 30
using the IO Accelerator as a swap 29
using Trim 57
utilities 41
utilities reference 41
V
verifying page file operation 64
Virtual Memory performance 64
W
Windows Installer logging options 33
Windows page file management 62
Windows page files 60
Windows page files, introduction 60
Windows Server 2003 22
Windows Server 2008 23
Windows Server 2012 23
Windows Server environments 12