Add-storeserv, Preconditions, Syntax – HP 3PAR Recovery Manager Software User Manual
Page 63
•
Scenario 3: Login failure on Hyper-V host.
RMH Server cannot authenticate with specified Hyper-V host.
•
Scenario 4: Storage System session credentials are invalid.
Storage System session credentials provided are invalid.
•
Scenario 5: Storage System credentials is already specified.
User is already logged in with specified Storage System.
•
Scenario 6: Cannot start RMH session.
Failure occurred to start session. Reason displayed.
Add-StoreServ
Add-StoreServ
is used for each HP 3PAR StoreServ credentials.
•
HP 3PAR StoreServ credentials are associated to a specific Microsoft Hyper-V
•
This command is only required to initially set up credentials. The command is persisted by
RMH Server until the user removes it.
•
The user can Add/Remove/Update HP 3PAR StoreServ credentials at any time during the
session
Preconditions
•
The user must first login with Login-Rmh.
•
HP 3PAR StoreServ name must not already exist for specified Microsoft Hyper-V
Syntax
Any optional parameters require square brackets [ ] around them.
Add-StoreServ -RmhServerName <RmhServerName> -HypervName <HypervName>
-StoreServName <StoreServName> -StoreServUsername <StoreServUsername>
-StoreServPassword <StoreServPassword> [-Verbose]
Table 36 Add-StoreServ parameters
Description
Optional/Required
Parameter
Host name of the RMH Server. This is
FQDN or IP address.
Required
-RmhServerName
This is FQDN or IP address. Synonyms
are supported. The localhost is not
supported.
Required
-HypervName
This is FQDN or IP address, etc.
Synonyms for HP 3PAR StoreServ are
supported.
Required
-StoreServName
Note, if not provided, a dialog box will
pop up asking for credentials.
Required
-StoreServUsername
Note, if not provided, a dialog box will
pop up asking for credentials.
Required
-StoreServPassword
Displays progress messages
Optional
-Verbose
Add-StoreServ
63