HP Photosmart D5345 Printer - Manual (Page 108)

printable side up and reinsert the holder into the CD/DVD tray until the lines on the
holder line up to the white lines on the tray. When the HP Photosmart detects the
holder, the prompt disappears.
The HP Photosmart does not detect a CD/DVD on the holder
Cause: You inserted the CD/DVD holder into the CD/DVD tray without loading a
CD/DVD onto the holder.
Solution: Remove the CD/DVD holder from the CD/DVD tray. Load a printable disc
onto the CD/DVD holder with the printable side up and reinsert the holder into the
CD/DVD tray until the lines on the holder line up to the white lines on the tray.
Cause: You might have loaded the CD/DVD upside down on the holder.
Solution: Remove the CD/DVD holder from the CD/DVD tray. Load a printable disc
onto the CD/DVD holder with the printable side up and reinsert the holder into the
CD/DVD tray until the lines on the holder line up to the white lines on the tray.
The HP Photosmart stalled while printing a CD/DVD
Cause: The HP Photosmart pulls the CD/DVD holder through the device while
printing on the CD/DVD. The holder can protrude about 7.5 cm (3 inches) from the
back of the device. If there is not sufficient space behind the HP Photosmart, the
holder stops and printing stalls.
Solution: Ensure that there is at least 7.5 cm (3 inches) of space behind the
HP Photosmart. Also, make sure that the slot on the back of the HP Photosmart is
not blocked.
The image on my printed disc is cropped and there is ink on the CD/DVD holder
Cause: You loaded the CD/DVD onto the CD/DVD holder incorrectly.
Solution: If you are loading a regular-size (120 mm) CD/DVD onto the CD/DVD
holder to be printed, do not flip the blue ring over the disc. The blue ring should only
be used if you are printing on a small-size (80 mm) CD/DVD.
Before trying again, clean the CD/DVD holder to remove ink from the holder. This
avoids ink contamination within the device, as well as protects your discs, hands, and
clothing from stains later.
After the CD/DVD holder is clean and dry, load a new printable disc onto the holder
with the printable side up. Leave the blue ring in its original location on the opposite
side of the holder from your disc, as shown below. Reinsert the holder into the CD/
CD/DVD print troubleshooting 107
Trou
bles
ho
ot
ing