HP Insight Management-Software - Manual (Page 46)

set fcoe-connection
The -set fcoe-connection command modifies an existing FCoE connection.
Syntax
set fcoe-connection –profilename <profileName>
-portnumber <PortNumber>
[[-fabric <FabricName>] | [–fcoenetwork <FCoENetworkName> ]]
[-speedtype <1Gb|2Gb|4Gb|8Gb|Custom|Disabled>]
[–customspeed <100–10000>]
[–bootpriority <priority>]
[–bootport <portName>]
[–bootlun <LUN>]
Parameters
Table 17 Parameter descriptions for -set fcoe-connection
Optional Required Description Parameter
x Specifies the name of the
profile to which the FcOE
connection will be assigned. -profilename
x Specifies the port number of
the connection. -portnumber
x Specifies the name of the
FCoE SAN fabric to -fabric
associate with the
connection.
x Name of an existing FCoE
network associated with the
connection.
NOTE: You cannot specify
both Fabric and
FcoeNetwork properties. If
neither property is specified,
the connection is marked as
Unassigned but associated
with a specific bay.
-fcoenetwork
x Specifies the requested
operational speed for the -speedtype
server port. Valid values
include 1Gb, 2Gb, 4Gb,
8Gb
, auto, custom,
disabled , and
preferred . If the speed
type is custom, you can
configure any speed from
100 Mb to 10 Gb in 100
Mb increments. The
-customspeed
parameter
is required if the speed type
is custom and is the
user-defined speed for the
server port. Valid values
include 100 Mb to 10 Gb
configured in 100 Mb
increments. The acceptable
value is 100 Mb/s to
10,000 Mb/s.
46 Using VCEM commands