Altinex Pop 'N Plug Interconnect Box PNP200 - Manual (Page 3)

ACCESSORIES
2
2
PRECAUTIONS / SAFETY WARNINGS 1
Please read this manual carefully before using your
PNP200 Interconnect Box. Keep this manual handy
for future reference. These safety instructions are
to ensure the long life of your PNP200 and to
prevent fire and shock hazard. Please read them
carefully and heed all warnings.
1.1 GENERAL
•
Unauthorized personnel shall not open the unit
since there are high-voltage components
inside.
•
Qualified Altinex service personnel, or their
authorized representatives must perform all
service.
1.2 INSTALLATION
•
For best results, place the PNP200
Interconnect Box in a dry area away from dust
and moisture.
•
To prevent fire or shock, do not expose this
unit to rain or moisture. Do not place the
PNP200 Interconnect Box in direct sunlight,
near heaters or heat radiating appliances, or
near any liquid. Exposure to direct sunlight,
smoke, or steam can harm internal
components.
•
Handle the PNP200 Interconnect Box
carefully. Dropping or jarring can damage
internal components.
•
Never place fingers inside the openings in the
back of the unit. This action could cause
serious injury because of the sharp edges
inside of the PNP200.
•
Do not place heavy objects on top of the
PNP200. Do not use excessive force to push
down on the top of the unit.
•
To turn off main power, disconnect the power
cord, which powers the power socket on the
PNP200 pop-up panels only, and unplug the
9V 500mA-power supply. The power outlet
socket should be installed as near to the
equipment as possible, and should be easily
accessible.
•
We recommend using wall outlets with a
Ground Fault Circuit Interrupter (GFCI) for
maximum protection.
•
Install all cables according to the instructions.
Do not force or pull out any cable or power
cord that is attached to the PNP200
Interconnect Box.
1.3 CLEANING
•
Surfaces should be cleaned with a dry cloth.
Never use strong detergents or solvents, such
as alcohol or thinner. Do not use a wet cloth or
water to clean the unit.
1.4 FCC / CE NOTICE
•
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
that which may cause undesired operation.
•
This equipment has been tested and found to
comply with the limits for a Class A digital
device, pursuant, to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference when the equipment is operated
in a commercial environment. This equipment
generates, uses, and can radiate radio
frequency energy and, if not installed and used
in accordance with the instruction manual, may
cause harmful interference to radio
communications. Operation of this equipment
in a residential area is likely to cause harmful
interference in which case the user will be
required to correct the interference at his own
expense.
•
Any changes or modifications to the unit not
expressly approved by Altinex, Inc. could void
the user’s authority to operate the equipment.