HP ProCurve 520wl Wireless Access Point - Manual (Page 97)

Set Basic Configuration Parameters using CLI Commands
6-14
set basic configuration parameters using cli commands set basic configuration parameters using cli commands set basic configuration parameters using cli commands set basic configuration parameters using cli commands
There are a few basic configuration parameters that you will want to setup right away when you receive the WL520 unit. For
example:
– Set System Name, Location and Contact Information
– Set Static IP Address for the WL520 device
– Set Network Names for each Wireless Interface
– Set WEP Encryption for each Wireless Interface
– Change Passwords
– Download an WL520 Configuration File from your TFTP Server
– Backup your WL520 Configuration File
set system name, location and contact information set system name, location and contact information set system name, location and contact information set system name, location and contact information
[Device Name]>set sysname <system name> sysloc <Unit Location>
[Device Name]>set sysctname <Contact Name (person responsible for system)>
[Device Name]>set sysctphone <Contact Phone Number> sysctemail <Contact E-mail address>
[Device Name]>show system <CR>
Figure 6-11 Figure 6-11 Figure 6-11 Figure 6-11 Result of “show system” CLI Command Result of “show system” CLI Command Result of “show system” CLI Command Result of “show system” CLI Command
set static ip address for the wl520 device set static ip address for the wl520 device set static ip address for the wl520 device set static ip address for the wl520 device
NOTE:
The IP Mask of the WL520 unit must match your network IP Mask. If you are setting up the WL520 device from a
client station, check the IP mask of your computer before proceeding.
[Device Name]>set ipaddrtype static
[Device Name]>set ipaddr <fixed IP address of unit>
[Device Name]>set ipsubmask <IP Mask (default = 255.0.0.0)>
[Device Name]>set ipgw <gateway IP address (default = 10.0.0.1)>
[Device Name]>show network<CR>