HP Scanjet G2410 Flatbed Scanner - Manual (Page 13)

Figure 1-2 Scan negatives
1. Open the scanner lid.
2. Remove the negative strip holder from the slide holder.
3. Do one of the following to load the slides or negatives:
• If you are scanning slides, place the slides into the slide holder. Insert the slides
with the top of the slides pointing up and with the front of the slides facing you.
Make sure that the slides are flat and do not overlap.
• If you are scanning negatives, do the following:
a. Slide a negative strip with one or two frames into the negative strip holder so that
the shiny side of the negative faces you. Negatives are easily damaged, so you
should touch them only on their edges.
b. Insert the negative strip holder back into the slide holder.
4. Close the scanner lid.
5. Press the Scan (
) button on the scanner, or click Scan in HP Solution Center.
6. In the What are you scanning? dialog box, select Picture.
7. If you are scanning slides, select Scan positives, including 35 mm slides, using
the TMA. If you are scanning negatives, select Scan negatives using the
Transparent Materials Adapter (TMA).
If you want to preview the scanned picture, select the Show Preview check box on
the screen, or begin the scan from HP Solution Center.
8. Click Scan.
9. Follow the instructions on the screen to finish scanning.
The scan is sent to the default destination.
10. When the scan is finished, remove the slides. Place the negative strip holder back
into the scanner lid for convenient storage.
Scan film 11