HP Integrity rx4610 Server - Manual (Page 47)

Chapter 5: Installing Additional Memory
40
9. Place the memory board on a clean ESD-protected surface.
Figure 5-4. Memory Boards
Installing Memory Boards
Two memory boards exist, one plugged into each side of the Processor Baseboard (the top and the
underside of the Processor/Memory Complex). This procedure describes the installation process for
either memory board. To re-install the memory board or install a new board, complete the following
procedure:
1. Observe all safety and ESD precautions.
2. Remove the Processor/Memory Complex as described in “Removing the Processor/Memory
Complex” in Chapter 5.
3. With both extraction levers raised to engage the guide pins, place the memory board over the
Processor Baseboard connector and guide pins
4. Engage both guide pins at the same time. Ensure that the memory board remains parallel to
the Processor Baseboard.
NOTE Both extraction levers must be depressed evenly while inserting the Memory
Board. The Memory Board must remain parallel to the Processor Baseboard
during insertion.
5. Slowly depress the levers until the Memory Board connector fully engages.