HP ENVY 111 e-All-in-One Printer - D411d - Manual (Page 34)

❑ Touch WiFi Protected Setup.
❑ Touch PIN.
b. Set up wireless connection.
❑ Touch Start.
The device displays a PIN.
❑ Enter PIN on WPS-enabled router or other networking device.
NOTE: The product begins a timer for approximately two minutes in which the PIN needs to be
entered on the networking device.
❑ Touch OK.
c. Install software.
Wireless with a router (infrastructure network)
To connect the HP ENVY 110 series to an integrated wireless WLAN 802.11 network, you will need the following:
❑ A wireless 802.11 network that includes a wireless router or access point.
❑ A desktop computer or laptop with either wireless networking support, or a network interface card (NIC). The
computer must be connected to the wireless network that you intend to install the HP ENVY 110 series on.
❑ Broadband Internet access (recommended) such as cable or DSL.
If you connect the HP ENVY 110 series on a wireless network that has Internet access, HP recommends that
you use a wireless router (access point or base station) that uses Dynamic Host Configuration Protocol
(DHCP).
❑ Network name (SSID).
❑ WEP key or WPA Passphrase (if needed).
To connect the printer with the Wireless Setup Wizard
1. Write down your network name (SSID) and WEP key or WPA passphrase.
2. Start Wireless Setup Wizard.
▲ Touch Wireless Setup Wizard.
3. Connect to wireless network.
▲ Select your network from the list of detected networks.
4. Follow prompts.
5. Install software.
Related topics
• Install the software for a network connection on page 32
Install the software for a network connection
Use this section to install the HP ENVY software on a computer connected to a network. Before you install the
software, make sure you have connected the HP ENVY 110 series to a network. If the HP ENVY 110 series has
not been connected to a network, follow the onscreen instructions during the software installation to connect the
product to the network.
NOTE: Installation time can vary depending on your operating system, the amount of available space, and
the processor speed of your computer.
To install the Windows HP ENVY Software on a networked computer
1. Quit all applications running on your computer.
2. Insert the installation CD that came with the product into the CD-ROM drive on your computer and follow the
onscreen instructions.
NOTE: If the HP ENVY 110 series is not connected to a network, run the Wireless Setup Wizard from
the Network menu on the HP ENVY 110 series.
Chapter 9
32 Connectivity
Connectivity