HP Deskjet 6620 Color Inkjet Printer - Manual (Page 30)

Resetting the printer to its factory default settings will clear all the settings from the
printer's memory for your network. This should only be done as a last resort when
troubleshooting the printer.
Also, resetting the printer to its factory default settings erases the
embedded Web
server (EWS) administrator password.
Resetting the printer to its factory default settings may require you to reinstall the
printer software. Additionally, you will also have to reconfigure the printer's security
settings.
Follow these steps to reset the printer to the factory default settings:
1. Verify that the printer is powered on.
2. Press and hold down the Report Page button.
3. While holding down the Report Page button, press the Cancel button three
times.
4. Release the Report Page button.
4.2.12 Networking glossary
numbers
10/100 Base-T: A technical term for Ethernet. 10/100 refers to the speed at which
the Ethernet network functions. 10 indicates 10 megabits per second (Mb/s) for
normal Ethernet, and 100 indicates 100 Mb/s for Fast Ethernet.
a
AutoIP: A process by which a device on a network automatically assigns an IP
address to itself.
b
BOOTP: Bootstrap Protocol (BOOTP) is an Internet protocol that enables a device
to discover its own IP address, the IP address of a BOOTP server on the network,
and a file to be loaded into memory to boot the machine. This enables the device
to boot without requiring a hard or floppy disk drive.
Broadcast packet: A packet sent from one device on a network to all devices on the
network.
d
DHCP (Dynamic Host Configuration Protocol): A protocol used to automatically
assign an IP address to each device on a network.
e
EAP: Extensible Authentication Protocol (EAP) is a general protocol for
authentication that also supports multiple authentication methods, such as token
cards, one-time passwords, certificates, and public key authentication.
HP Deskjet 6600 series printer
30