HP 3Gb SAS Switch for HP BladeSystem c-Class - Manual (Page 74)

2. Create the zone group.
This example shows how to create a zone group named zone5, using drive bays 29 through
35 on a storage enclosure connected to port 1 of a switch in interconnect bay 7.
=> sw local startupdate
Success
=> sw local create type=zg zonegroupname=zone5 seb=71:1:29,71:1:30,71:1:31,
71:1:32,71:1:33,71:1:34,71:1:35
Success
=> sw local saveupdate
Success
3. [Optional] Verify that the zone group was created as intended.
For example, use one of the following commands:
=> sw local seb all show detail
=> sw local zg zone5 show
The display of this example is abbreviated, retaining key details. Drive bays 29 through 35
are now included in the zone group zone5.
=> sw local seb all show detail
Blade Enclosure at BottomC7000
Switch: Local
Storage Enclosure: 5001438002866100, PortBox=71:1 (OK)
Bay: 1, ID: 71:1:1, SAS, OK, ZoneGroup: zone1
Bay: 2, ID: 71:1:2, SAS, OK, ZoneGroup: zone1
Bay: 3, ID: 71:1:3, SAS, OK, ZoneGroup: zone1
Bay: 4, ID: 71:1:4, SAS, OK, ZoneGroup: zone1
Bay: 5, ID: 71:1:5, SAS, OK, ZoneGroup: zone1
Bay: 6, ID: 71:1:6, SAS, OK, ZoneGroup: zone1
Bay: 7, ID: 71:1:7, SAS, OK, ZoneGroup: zone1
.
.
.
Bay: 29, ID: 71:1:29, SAS, OK, ZoneGroup: zone5
Bay: 30, ID: 71:1:30, SAS, OK, ZoneGroup: zone5
Bay: 31, ID: 71:1:31, SAS, OK, ZoneGroup: zone5
Bay: 32, ID: 71:1:32, SAS, OK, ZoneGroup: zone5
Bay: 33, ID: 71:1:33, SAS, OK, ZoneGroup: zone5
Bay: 34, ID: 71:1:34, SAS, OK, ZoneGroup: zone5
Bay: 35, ID: 71:1:35, SAS, OK, ZoneGroup: zone5
74 Performing common tasks