HP StorageWorks 1000 Modular Smart Array - Manual (Page 65)

Regulatory Compliance Notices
65 MSA1000 Controller User Guide
BSMI Notice
Laser Compliance
The SFP Module contains a laser diode of either gallium aluminum arsenide
(GaALAs) emitting in the wavelength range of 770-860 nm, or indium gallium
arsenide phosphide (InGaAsP) emitting in the wavelength range of 1270-1355
nm. All HP systems equipped with a laser device comply with safety standards,
including International Electrotechnical Commission (IEC) 825. With specific
regard to the laser, the equipment complies with laser product performance
standards set by government agencies as a Class 1 laser product. The product does
not emit hazardous laser radiation.
WARNING: Use of controls or adjustments or performance of procedures
other than those specified herein or in the laser product’s installation guide
may result in hazardous radiation exposure. To reduce the risk of exposure to
hazardous radiation:
■
Do not try to open the unit enclosure. There are no user-serviceable
components inside.
■
Do not operate controls, make adjustments, or perform procedures to the
laser device other than those specified herein.
■
Allow only HP Authorized Service technicians to repair the unit.
The Center for Devices and Radiological Health (CDRH) of the U.S. Food and
Drug Administration implemented regulations for laser products on August 2,
1976. These regulations apply to laser products manufactured from August 1,
1976. Compliance is mandatory for products marketed in the United States. This
device is classified as a Class 1 laser product as defined by IEC 825.