HP StorageWorks 3000 RAID Array - Manual (Page 28)

2-2 Command Console V2.2 for the RAID Array 3000 (Pedestal and Rack Mount Models) User’s Guide
Compaq Confidential – Need to Know Required
Writer: Bob Young Project: Command Console V2.2 for the RAID Array 3000 (Pedestal and Rack Mount Models) User’s Guide Comments:
Part Number: AA-RBF2C-TE File Name: c-ch2 Installing and Setting Up the Command Client.doc Last Saved On: 12/5/00 10:31 AM
This chapter will tell you how to complete these steps. For information on how
to upgrade the controller firmware, refer to the Getting Started RAID Array
3000 Installation Guide for your operating system and platform.
This chapter also contains information on how to add an Agent system to the
Navigation Tree. This chapter also provides information on setting up the
Command Console so it sends fault notification by pager. The Navigation Tree
shows the status of your storage systems in the Navigation window. The
Navigation window is the window that appears when you click
Start|Programs|Command Console|StorageWorks Command Console.
Installing Command Console Client
You can install the Command Console Client from a CD-ROM onto
Windows NT 4.0 SP4, and Windows 2000. The installation program is self-
extracting and it installs the Command Console Client into the directory
C:\program files\SWCC by default. During setup, you have the option to
install the program on a different hard drive.
Before you install the Client software, you should read the release notes that
came with this kit. If you have the Command Console Client version 1.1b or
earlier, remove the program and the Asynchronous Event Service (AES).
Install the client software as follows:
1. Place the CD titled RA3000 Solution Software Version 1.3 in the CD-
ROM drive.
2. Run File Manager or Windows Explorer.
3. Navigate to the folder drive_letter:\SWCC
4. Double-click Setup.
5. Follow the instructions in the setup program to complete the installation.