HP Hitachi Dynamic Link Manager Software - Manual (Page 118)

3. Creating an HDLM Environment
94
3.5.3 Performing a New Installation of HDLM on Windows Server
2003
(1) In a Non-Cluster Environment
Before installing HDLM, have a license key ready.
If you want to perform an unattended installation, also be sure to prepare an
installation-information settings file.
To install HDLM on a host that does not currently have HDLM installed on it:
1.
Log on to Windows as a member of the Administrators group.
2. Save the license key file directly under the Windows installation-destination
drive.
installation-drive
:\hdlm_license
The license key file will be deleted after the installation finishes.
3. Perform the installation.
• If you are not performing an unattended installation, insert the DVD into the
drive and run the installation program
setup.exe
.
The program checks whether HDLM has already been installed. If HDLM
5.4 or earlier has been installed, the KAPL09129-E message will appear. If
this happens, carry out the procedure shown in 3.5.6 Migrating from HDLM
5.4 or Earlier to HDLM 5.5 or Later. If HDLM 5.5 or later has been
installed, the KAPL09173-W message will appear. If this happens, carry out
the procedure shown in 3.5.5 Upgrade Installation or Re-installation of
HDLM. If no message appears, go to step 4.
• If you are planning to perform an unattended installation, execute the
installhdlm
utility.
At the command prompt, execute the following command:
drive-to-which-the-installation-DVD-is-inserted
:\HDLM_Windows\DLMTo
ols\installhdlm -f
installation-information-settings-file
This command checks whether HDLM has already been installed. If HDLM
5.4 or earlier has been installed, the KAPL09129-E message will appear. If
this happens, carry out the procedure shown in 3.5.6 Migrating from HDLM
5.4 or Earlier to HDLM 5.5 or Later. If HDLM 5.5 or later has been
installed, the KAPL09183-E message will appear, and then the upgrade
installation or re-installation will be performed.