HP EliteBook 2170p Notebook PC - Manual (Page 55)

Replacing or upgrading the hard drive
CAUTION: To prevent information loss or an unresponsive system:
Shut down the computer before removing the hard drive from the hard drive bay. Do not remove the
hard drive while the computer is on, in Suspend, or in Hibernation.
If you are not sure whether the computer is off or in Hibernation, turn the computer on by sliding the
power switch. Then shut down the computer through the operating system.
Removing the hard drive
To remove a hard drive:
NOTE: The smart card reader is located on top of the hard drive. Because of this, you must first
move the smart card reader out of the way before you can access the hard drive.
1. Save your work and shut down the computer.
2. Disconnect AC power and external devices connected to the computer.
3. Turn the computer upside down on a flat surface.
4. Remove the battery (see Inserting or removing the battery on page 36 ).
5. Remove the service door (see Removing the service door on page 43 ).
6. Remove the 4 hard drive screws (1).
7. Pull the hard drive tab (2) to lift the hard drive out of the hard drive bay
Replacing or upgrading the hard drive 45