HP Color Inkjet cp1700 Printer series - Manual (Page 17)

ENWW 2-11
Tips for loading paper
l The default size of Tray 1 and Tray 2 is 8.5 by 14 in (215.9 by 355.6
mm). When you want to print on media smaller than this, you need
to adjust the paper width and paper length guides in the tray before
you load the media.
l You can extend Tray 1 and Tray 2 to accommodate A3, 11 by 17 in,
and 13 by 19 in/A3+ media.
l Insert media vertically (portrait orientation). If you want to print
horizontally (landscape orientation), make the selection through
your software.
l To prevent multiple picks and paper jams, load only one type of
media at a time into a paper path. Also, when adding media, always
remove the existing media and realign it with the new media before
loading.
To load Tray 1 or Tray 2
1 To load Tray 1, lift the output tray. You can either load media with
Tray 1 in place, or pull Tray 1 out of the printer to load the media.
To load Tray 2, remove the tray completely by grasping the handle
under the front of the tray and pulling the tray towards you.
2 Pinch and slide the paper length guide and paper width guide to
their outermost positions.
3 If you are loading paper larger than legal size, follow these steps to
extend the tray:
a Locate the tray extension lock on the front left part of the tray.
b Slide it to the left, and then release it.
c Pull the tray out lengthwise until it clicks into place. This extends
the tray to support media up to 13 by 19 in/A3+ in size.
EulerUG.book Page 11 Monday, July 16, 2001 5:34 PM