HP ProLiant DL360p Gen8 Server - Manual (Page 70)

Hardware options installation 70
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Remove the server from the rack, if necessary (" Remove the server from the rack " on page 21 ).
4. Place the server on a flat, level work surface.
5. Remove the access panel (on page 23 ).
6. Remove the PCI riser cage (on page 24 ).
CAUTION: Any attempt to remove an installed TPM from the system board breaks or disfigures
the TPM security rivet. Upon locating a broken or disfigured rivet on an installed TPM,
administrators should consider the system compromised and take appropriate measures to ensure
the integrity of the system data.
7. Install the TPM board. Press down on the connector to seat the board (" System board components " on
page 12 ).
8. Install the TPM security rivet by pressing the rivet firmly into the system board.
9. Install the PCI riser cage (on page 25 ).
10. Install the access panel (on page 23 ).