HP Insight Cluster Management Utility User Manual
Page 137
[16:25:06] [DollyClient] Device is sda
[16:25:06] [DollyClient] Asking for partition table of "/dev/sda"
[16:25:06] [DollyClient] Getting /opt/cmu/image/test_julien/parttbl-sda.txt
[16:25:07] [DollyClient] Getting /opt/cmu/image/test_julien/parttbl-sda.raw
[16:25:07] [DollyClient] Getting /opt/cmu/image/test_julien/partarchi-sda1.tgz (1/5)
[16:25:17] [DollyClient] Getting /opt/cmu/image/test_julien/partarchi-sda5.tgz (2/5)
[16:25:38] [DollyClient] Getting /opt/cmu/image/test_julien/partarchi-sda6.tgz (3/5)
[16:25:45] [DollyClient] Getting /opt/cmu/image/test_julien/partarchi-sda8.tgz (4/5)
[16:25:46] [DollyClient] Getting /opt/cmu/image/test_julien/partarchi-sda9.tgz (5/5)
[16:25:46] [DollyClient] Image test_julien received
[16:25:46] Dolly Terminated...
backup success
The golden image node will be rebooted in 30 seconds
/opt/cmu/tmp/GUI/config.txt was rewritten
cmu>
where:
test_julien
is the name of the logical group containing the node being backed up.
sda1,sda5,sda9
are the partitions on the hard drive.
o185i195
is the node name.
Modifying a management card password
Modifies the management card password in the HP Insight CMU database.
cmu> modify_password ILO|ILOCM|lo100i
For example:
cmu> modify_password lo100i
login> hp
password> service
password successfully changed
cmu>
IMPORTANT:
You can only change the password in the HP Insight CMU database. This command
does not change the actual password of the card. The password is echoed during this command.
Discovering MAC address for new nodes
The scan_macs command enables discovering the MAC address for new nodes. Enter parameters
interactively. For example:
cmu> scan_macs
Enter the number of nodes to scan: 2
Enter the first nodename: node1
Enter the prefix of the node: node
Enter the IP address of the first node: 16.16.184.115
Enter the netmask of the first node: 255.255.248.0
Enter the BMC type (ex. ILO, lo100i): ILO
Enter the IP address of the first BMC: 16.16.188.115
Scanning 2 nodes.
First nodename is 'node1'.
The prefix is 'node'.
The first IP address is '16.16.184.115'.
The netmask is '255.255.248.0'.
The BMC type is 'ILO'.
The first BMC IP address is '16.16.188.115'.
Is this correct? ([y]/n): y
Scanning. Please be patient. This process can take up to 10 minutes...
Scanning complete. 2 nodes added, 0 nodes updated.
cmu>
7.17 HP Insight CMU CLI
137