HP Insight Cluster Management Utility - Manual (Page 19)

◦ Numlock Enabled
◦ Restore after AC loss Last state
◦ Post F1 prompt Delayed
•
CPU setup
Proc hyper threading Disabled ◦
•
IDE configuration
SATA controller mode AHCI ◦
◦ Drive cache Enabled
◦ IDE timeout 35
•
Chipset ACPI configuration
High Performance Event timer Enabled ◦
•
IPMI serial port configuration
Serial port assignment BMC ◦
◦ Serial port switching Enabled
◦ Serial port connection mode Direct
•
LAN configuration
If your node is wired with the LO100i management port shared with NIC2:
◦ BMC NIC Allocation Shared
◦ LAN protocol: HTTP, telnet, ping Enabled
Otherwise, if your node is wired with a dedicated management port for LO100i:
◦ BMC NIC Allocation Dedicated
◦ LAN protocol: HTTP, telnet, ping Enabled
•
Remote Access
BIOS Serial console Enabled ◦
◦ EMS console support Enabled
◦ Flow control Node
◦ Redirection after BIOS POST Enabled
◦ Serial port 9600 8,n,1
•
Boot device priority
Network ( 0500 ) ◦
◦ Removable device
◦ Hard Disk
•
Enable PXE for the NIC that is connected to the administration network.
2.1 Installing HP Insight CMU 19