HP Systems Insight Manager - Manual (Page 190)

on the hosts, the updated name does not reflect on the 'All Systems Page". However, the change
is updated in the host system page after few minutes.
For the VM name to be updated and reflected in the All Systems system list page, initiate an
identification task on the host System Page.
-------------------------------------------------------------
After you have selected the Install Linux PSP or ESX agents and Register VM host options in a
Configure or Repair Agents task for ESX 3.5 U4 or later, the VM-host registration task fails because
the system shows as Not Responding in Vcenter. Vcenter takes about five minutes for a system to
reach a Normal status and therefore fails when HP SIM tries to register the VM host. Re-run the
VM-host registration task at a later time when the server is in a Normal state in Vcenter.
HP Smart Update Manager
Online deployment through HP SUM is not supported for Itanium based systems.
-------------------------------------------------------------
To install HP SUM, you must select the following additional libraries on the system running HP
SUM:
•
Compatibility libraries
•
Under Hardware Monitoring Utilities, the following must be selected:
lm_sensor-3.1.1-10.e16 ◦
◦ Under Systems Management:
Select SNMP Support.
◦ Under Desktops.
– Select X Windows System.
– Select Legacy X Windows System Compatibility.
– Select either the Gnome or KDE Desktop.
– Under Development Tools, the following must be selected:
– expect-5.44.1.15-2.el6.
The prerequisites for Red Hat Enterprise Linux 6 servers - RHEL6 Console Mode:
NOTE: No X console in either x86 or x86_64 - User installs base server with defaults and the
following RPMs to run HP SUM in silent mode.
NOTE: The versions below are needed as a minimum. Later versions of these can most likely be
used as well.
•
lm-sensors-libs-3.1.1-10.el6.<arch>.rpm
•
net-snmp-libs-5.5-27.el6.<arch>.rpm
•
net-snmp-5.5.27.el6.<arch>.rpm
•
kernel-headers-2.6.32-71.el6.<arch>.rpm
•
redhat-rpm-config-9.0.3-25.el6.noarch.rpm
•
kernel-devel-2.6.32-71.el6.<arch>.rpm
•
rpm-build-4.8.0-12.el6.<arch>.rpm
•
gcc-4.4.4-13.el6.<arch>.rpm
For Red Hat Enterprise Linux 6 servers - RHEL6 Graphical Mode:
190 Troubleshooting