HP 2310mfd 23 inch Diagonal LCD Monitor - Manual (Page 13)

11
LOCATING THE MFM CONNECTORS AND CONTROLS
Before connecting any external equipment to the monitor, turn off all main power switches on the
external equipment. If there is no switch, remove the main power plug from the wall socket.
Connect the power cord into the AC IN socket found at the back of the MFM.
NOTE:
Please use the power cord (included) with a grounded (earthed) pin and two flat current-carrying •
pins. Use only the power cord received with this monitor.
ATV Connectors
AC IN
PC IN
RGB/PC AUDIO
SERV.C
HDMI 1
Y Pb Pr L R
Y Pb Pr L R COAXIAL
VIDEO L R
AV IN
VIDEO L R
AV OUT
TV
COMPONENT 1
COMPONENT 2
4
7
5 3
6
2
1
1. HDMI1 (input terminals) — High-Definition Multimedia Interface input receives digital
audio and uncompressed digital video from an HDMI device or uncompressed digital video from
a DVI device (
page 16-17).
2. PC IN (VGA / Audio) input terminal — For use when connecting a personal computer
(PC) ( page 17).
3. Component (Video and L/R Audio) input terminal — For use when connecting a high-
definition component video device with standard audio output. ( page 14).
TV (Antenna input terminal) — 4. Analogue TV antenna signal input ( page 8).
5. AV IN input terminals — For use when connecting a composite video device.
6. AV output terminals — For use when connecting an video recorder with standard video
and standard audio input.
7. Digital Audio (coaxial) output terminals — For use when connecting an amplifier with
coaxial type digital audio input ( page 15).