HP StorageWorks Scalable File Share - Manual (Page 196)

Changing the system parameters 7–14
4. Enter the
configure system
command, and then enter
2
to select the
Configure Networks
menu, as follows:
sfs> configure system
1) System
2) Configure Networks
3) Network Services
4) Management Network
5) iLO Access
6) Storage
a) All of the above
e) Exit (save updates)
q) Quit (discard updates)
Enter your choice [a]: 2
5. The
Configure Networks
menu is displayed. Enter
2
to select the option to configure the
InfiniBand interconnect, as follows:
Configure Networks -------------------------------------------------------------
.
.
.
1) Configure Gigabit Ethernet Networks
2) Configure InfiniBand Interconnect
3) Configure Quadrics Interconnect
a) All of the above
n) Next Section
p) Previous Section
c) Cancel
Enter your choice [a]: 2
6. The
Configure InfiniBand Interconnect
menu is displayed. Enter
1
and then change the
partition key of the
ipoib0
device to
0xffff
. This will allow the servers to accept traffic on the
InfiniBand interconnect from any other system.
7. Delete each of the other interfaces on the InfiniBand interconnect, as shown in the following example,
where the
ipoib1
interface is deleted:
Configure InfiniBand Interconnect ----------------------------------------------
This section is used to configure the InfiniBand network on all servers.
This network is used as an interconnect to client systems. If you do not
have an InfiniBand interconnect you can proceed to the next section.
You must assign an IP address for ipoib0. In addition,
if you use fabric paritioning you must add an IB interface for each
partition that the SFS system should access.
Note: a network device is marked as Unused if a Start IP for the
network has not been entered. Once a Start IP is entered the device
is marked as Inuse.
1) ipoib0 Inuse
2) ipoib1 Inuse
3) Add IB Interface
4) Delete IB Interface
a) All of the above
n) Next Section
p) Previous Section
c) Cancel
Enter your choice [1]: 4
Delete IB Interface ------------------------------------------------------------
This section is used to delete an InfiniBand Interface.
Interface ipoib0 is not included an an interface that can be deleted.
1) ipoib1 Inuse
c) Cancel
Enter the interface to delete []: 1