Adding hp p4000 arrays, Adding hp msa2000 g2 arrays, Adding hp p4000 arrays adding hp msa2000 g2 arrays – HP OneView for VMware vCenter User Manual
Page 14
6.
Click Next.
The Add P6000 EVA (3 of 3) page appears, listing the storage pools on the selected P6000
EVA array.
7.
Select the Full Access check box for one or more storage pools to enable provisioning by the
Storage Module for vCenter.
If you will not perform provisioning operations on a particular storage pool, you do not need
to enable Full Access for that storage pool.
8.
Click Finish.
The array is added to the Configured Arrays and Management Servers list.
Adding HP P4000 arrays
To add an HP P4000 array (also called a management group):
1.
Log in to the Storage Administrator Portal.
For instructions, see
“About the Storage Administrator Portal” (page 10)
2.
Click Add.
The Add Storage Array or Management Server (1 of ...) page appears.
3.
Select HP P4000 in the Type list, and then click Next.
The Add HP P4000 (2 of 4) page appears.
4.
Enter the host name or IP address, user name, and password required to connect to a P4000
storage node managing the array you want to add, and then click Next.
The Add HP P4000 (3 of 4) page appears, displaying the specified array and all of its storage
nodes.
5.
Click Next.
The Add HP P4000 (4 of 4) page appears, listing the storage pools on the selected array.
6.
Select the Full Access check box for one or more storage pools to enable provisioning by the
Storage Module for vCenter.
If you will not perform provisioning operations on a particular storage pool, you do not need
to enable Full Access for that storage pool.
7.
Click Finish.
The storage node is added to the Configured Arrays and Management Servers list.
Adding HP MSA2000 G2 arrays
To add an HP MSA2000 G2 storage array:
1.
Verify that a supported version of the MSA2000 G2 firmware is installed.
For the supported firmware versions, see the HP SPOCK website:
2.
Ensure that the MSA2000 G2 SMI-S proxy provider is installed on the same server as the
Storage Module for vCenter.
The Insight Control for vCenter installer places version 1.1.2.0 of the MSA SMI-S proxy provider
installer and the HP MSA2000 G2 SMI-S Proxy Provider User Guide in the following folder
(assuming that the default installation directory was used):
•
X64 systems: C:\Program Files (x86)\HP\HP Insight Control Storage
Module for vCenter\MSA SMI-S Proxy Provider - Windows
•
32-bit systems: C:\Program Files\HP\HP Insight Control Storage Module
for vCenter\MSA SMI-S Proxy Provider - Windows
14
Configuring Insight Control for vCenter