ArtDio IPC 1000 - Manual (Page 4)

5. 030# Enable “static” IP mode.
6. 04210*62*149*250# Configures the IP Address “210.62.149.250”.
7. 05255*255*255*128# Configures the Subnet Mask “255.255.255.128”.
8. 06210*62*149*254# Configures the Default Gateway “210.62.149.254”.
9. 882834# The numbers ”2834” in this string are the web based management password.
10. 981# Restarts. (The system should be restarted immediately)
11. Hang up the phone
Note: This is the area code of the phone number. For example, “2” for Taipei, “21” for Shunghai, “10” for Peking and “408” for
San Jose (USA).
If want to setting the DHCP mode to get an IP, please follow the actions:
Using a phone to configure basic information
1. Pick up the phone and press
2. #0000 You will hear 3 short tones.
3. 012# The number “2” represents the Taipei area code.
4. 0282261111# The phone number is 82261111
5. 031# Enable “DHCP” IP mode.
6. 882834# The numbers ”2834” in this string are the web based management password.
7. 981# Restarts. (The system should be restarted immediately)
8. Hang up the phone
PPPoE modes use dynamically assigned IP addresses and because of this there are difficulties with regards to Web based
management. We strongly suggest that you use a private and fixed IP address such as 192.168.0.2 (default setting) so that you can
use the web based interface to configure the IPC 1000 series unit’s other advanced configurations.
1. Using a phone to configure information
1. Pick up the phone and press
2. ##0000 You will hear 3 short tones.
3. 012# The number “2” represents the Taipei area code.
4. 0282261111# The phone number is 82261111
5. 04192*168*0*2# Configures the IP Address “192.168.0.2”.
6. 05255*255*255*0# Configures the Subnet Mask “255.255.255.0”.
2. DHCP Mode
3. PPPoE Mode