ArtDio IPC 1000 - Manual (Page 9)

Local IPC 1000 series Remote IPC 1000 series
1. Assuming the user makes a traditional phone call through
the PSTN to reach a remote IPC 1000 series unit, for
example ”002862164458275” (You will then hear the ring
back tone).
After a few seconds the phone will begin ringing. (The FXO LED
should be flashing)
2. Waiting for the recipient to answer the phone, ask called
party to press the “ ” key twice. (Within one second)
Pick up the phone and press the“ ” key twice, the learning
procedure will begin.
3. Waiting for the recipient press the “ ” key twice, the
learning procedure should then begin. Later you will hear
short sounds that should continue for about 15 seconds
At this point the user will hear short sounds that should continue
for about 15 seconds
4. If the learning procedure was successful, you will hear three
short sounds in rapid succession.
Confirm that the learning process has completed successfully.
You should now be almost ready to commence voice
communication.
5. Hang up the phone to end the IP learning process
procedure.
Hang up the phone
The user can retry dialing a VoIP phone number, for example
“#002862164458275#”
The phone should ring. Pick up the phone to begin voice
communication over IP.
Join IIPN service
Contact your distributor and ask for a IPN service. After connecting to the IPN, you can get an IPN ID and make a VOIP call.
Example: # IPN ID #