GE GTDP740GDWW - Manual (Page 11)

6 Keeping the inner door on the flat protective surface and
the spacers in place, mount the outer door back onto the
inner door with the screws removed in step 4. Make sure
you mount the hinges on the side opposite the handle.
7 Mount the assembled door on the 2 upper left side hinge
screws installed in step 2. Move the hinge screws
loosened in step 3 into the lower left side screw holes
and firmly tighten all 4 screws.
8 Install the 4 plastic caps removed in step 1 into the 4
right side front panel holes.
NOTE: To return the door to the original setup, follow these
instructions, swapping “left” and “right”.
When you finish
Plug the dryer back into its electrical outlet.
11
GEAppliances.com
5 Remove and swap the 2 cover caps, 2 spacers and door
handle from the outer door:
A. Squeeze the tabs on the inside of the door handle
clips. Push clips through the outer door.
B. Squeeze the tabs on the inside of the cover caps. Push
caps through the outer door.
C. Push the door handle clips into the openings on the
opposite side of the outer door making sure you flip
the handle so it curves to the inside.
D. Push the cover caps into the openings on the outer
door where the handle was removed.
Door handle
Door handle clip
Cover cap
Inside of door
Door handle
Door handle clip
Inside of door
Cover cap
Door
Hang door and
tighten screws
E. Place the inner door on a flat protective surface and install
the 2 spacers in the handle side of the door as shown below.
Make sure to mate the spacer
flat surface with the inner
door surface and align the
holes on each part.
Spacers
Door
hinge
screws
Edge
screws Inside
screw
Inside
screw
Edge
screws
Handle
Spacers
Edge
screws
Edge
screw
Inside
screw
Inside
screw
Edge
screw
Inner door