Aga Ranges LEGACY 36 F104650-01 - Manual (Page 7)

7
SERVICING - WARNING
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
12. To Remove or Change a Cooktop
Burner.
Remove the cooktop tray (see 3). Remove the
control panel (see 2).
Outer Cooktop burners
The burners are mounted in 2’s on cross supports.
Disconnect the burner feed pipes at the burners.
Remove the screw at the front holding the
cross support. Slide the support to the right to
release in from the rear location. Lift the cross
support and burners clear. The burners are fi xed
to the cross supports with screws underneath.
Remove the appropriate burner and fi t the new
one. Reassemble in reverse order. Check burner
operation is satisfactory.
Wok burner
Disconnect the burner feed pipes at the burner.
Fit the new one and reassemble in reverse order.
Check burner operation is satisfactory.
13. To Remove Broiler Outer Door Panel
Open left hand oven door and remove 2 screws
from bottom edge of broiler door. Open broiler
door, support broiler door outer panel and remove
two screws from top inner face of broiler door.
There is a pad of fi bre insulation inside the door.
Reassemble in reverse order making sure that the
pad of insulation is in place.
14. To Remove Main Oven Door
Open oven door and remove Handyrack (where
fi tted) by springing one side out of the bracket on
the door and sliding the other side free. Support
the door and remove the two screws securing
the upper hinge and packing to the cooker front.
Remove the door from the lower hinge by lifting
slightly and moving outwards.
Reassemble in reverse order.