Installation air conditioner instructions, Important, Caution – GE AEM12AS User Manual

Page 7

Advertising
background image

BEFORE YOU BEGIN

Read these instructions completely

and carefully.

IMPORTANT

³6DYHWKHVHLQVWUXFWLRQV

for local inspector’s use.

IMPORTANT

³2EVHUYHDOOJRYHUQLQJ

codes and ordinances.

Note to Installer – Be sure to leave these

instructions with the Consumer.

• Note to Consumer – Keep these instructions for

future reference.

‡ 6NLOOOHYHO– Installation of this appliance requires

basic mechanical skills.

• Completion time

Approximately 1 hour

We recommend that two people install

this product.

Proper installation is the responsibility of the

installer.

Product failure due to improper installation is not

covered under the Warranty.

You MUST use all supplied parts and use proper

installation procedures as described in these

instructions when installing this air conditioner.

Installation

Air Conditioner

Instructions

Some models require a 115/120-volt AC,

60-Hz grounded outlet protected with a

15-amp time-delay fuse or circuit breaker.

The 3-prong grounding plug minimizes the possibility

of electric shock hazard. If the wall outlet you plan to

use is only a 2-prong outlet, it is your responsibility to

have it replaced with a properly grounded 3-prong wall

outlet.

Some models require 230/208-volt AC,

protected with a time-delay fuse or circuit

breaker. These models should be installed on

their own single branch circuit for best

performance and to prevent overloading

house or apartment wiring circuits, which

could cause a possible fire hazard from

overheating wires.

(/(&75,&$/5(48,5(0(176

CAUTION:

'RQRWXQGHUDQ\FLUFXPVWDQFHVFXWRUUHPRYH
WKHWKLUG JURXQG SURQJIURPWKHSRZHUFRUG
'RQRWFKDQJHWKHSOXJRQWKHSRZHUFRUG

of this air conditioner.
$OXPLQXPKRXVHZLULQJPD\SUHVHQWVSHFLDO
SUREOHPV³FRQVXOWDTXDOLILHGHOHFWULFLDQ

722/6<28:,//1(('

3KLOOLSVKHDGVFUHZGULYHU

Ruler or tape measure

Pencil

/HYHO

6FLVVRUVRUNQLIH

)ODWEODGHVFUHZGULYHU

Power cord includes a current interrupter device. A

test and reset button is provided on the plug case. The

device should be tested on a periodic basis by first

pressing the 7(67 button and then the 5(6(7 button

while plugged into the outlet. If the 7(67button does

not trip or if the 5(6(7 button will not stay engaged,

discontinue use of the air conditioner and contact a

qualified service technician.

7

4XHVWLRQV"&DOO*(&$5(6  RU9LVLWRXU:HEVLWHDW*($SSOLDQFHVFRP

Advertising
This manual is related to the following products: