GE AEE24DS - Manual (Page 4)

4
Heat
About the controls on the air conditioner.
Controls
Fan Fan
Remote Control
Delay timer Increase
Auto Fan on
Fan speed Increase
Unit power on/off
NOTE: The display always
shows the room temperature
except when setting the Set
temperature or the Delay timer.
Air Conditioner Controls
Light indicates the
delay timer is set.
Light indicates the unit
is in the temperature or
delay time Set mode.
Delay 1–24hr
Delay timer
Decrease
Mode select
Fan speed
Decrease
Temperature
set Increase
and Decrease
Features and appearance will vary.
Lights next to the touch pads on the air conditioner control panel indicate the selected settings.
Power Pad
Turns air conditioner on and off. When turned
on, the display will show the room temperature.
Display
Shows the room temperature or time remaining
on the Delay timer. Shows the Set temperature
while setting the temperature in Heat, Cool or
Energy Saver modes. The Set light will turn on
while setting.
Temp Increase Ÿ /Decrease ź Pads
Use to set temperature when in Heat, Cool or
Energy Saver mode. The Set light will turn on
while setting.
Delay Timer IncreaseŸ (+) /Decrease ź(–)
Pads
Each touch of the Increase Ÿ / Decrease ź
pads on the unit or the Increase + / Decrease
– pads on the remote control will set the delay
time when using the Delay 1–24hr timer. The
Set light will turn on while setting.
Fan Speed Pads
Use to set the fan speed to Low, Med, High
or Auto on the unit. NOTE: On the remote
control, use the fan speed Increase + /
Decrease – pads to set the fan speeds to Low,
Med or High. Use the Auto pad to turn Auto
fan on.
Mode Pad
Use to set the air conditioner to Heat, Cool,
Energy Saver or Fan Only mode.
Delay Pads
'HOD\21³When the air conditioner is off, it can
be set to automatically come on in 1 to 24 hours
at its previous mode and fan settings.
'HOD\2))³When the air conditioner is on,
it can be set to automatically turn off in 1 to
24 hours.
How to set:
Press the Delay 1–24hr pad on the unit or on the
remote control. Each touch of the Increase Ÿ
/ Decreaseźpads on the unit or the Increase
+ / Decrease – pads on the remote control will
set the timer in 1-hour intervals. The Set light will
turn on while setting.
To review the remaining time on the Delay
1–24hr timer, press the Delay 1–24hr pad on the
unit or on the remote control. Use the Increase
Ÿ
/ Decrease ź pads on the unit or the
Increase + / Decrease – pads on the remote
control to set a new time if desired.
To cancel the timer, press the Delay 1–24hr pad
until the light on the Delay 1–24hr pad goes off.
Note: The default temperature reading on the display is degree Fahrenheit ( °F). To change the display to
degree Celcius (°C), press the Temp Increase Ÿ and Temp Decrease ź buttons together and hold for 3
seconds. Repeat the process to change back to degree Fahrenheit (°F)