Warning, Provide adequate gas supply, Install regulator – GE PGP986SETSS User Manual

Page 6: Install regulator onto burner box bottom, Complete connection with a coupling

Advertising
background image

6

Installation Instructions

,167$//$7,21³*$6&211(&7,216

1

PROVIDE ADEQUATE

GAS SUPPLY

This cooktop is designed to operate on natural

gas at 5s of water column manifold pressure and

7s of water column (W.C.) supply pressure. It is

shipped from the factory set for natural gas. The

convertible pressure regulator supplied with the

unit must be connected in series with the manifold

of the cooktop and must remain in series with the

supply line regardless of whether natural or L.P.

gas is being used. FOR PROPER OPERATION, THE

MAXIMUM INLET PRESSURE TO THE REGULATOR

MUST BE NO MORE THAN 14s OF WATER COLUMN

PRESSURE. For checking the regulator, the inlet

pressure must be at least 1s W.C.. (or 3.4 KPA)

greater than the regulator output setting. If

the regulator is set for 5s W.C. of water column

pressure, the inlet pressure must be at least 6sW.C.

If the regulator is set for 10sW.C., the inlet pressure

must be at least 11sW.C.. The gas supply line to

the cooktop should be 1/2s or 3/4s pipe.

2

INSTALL REGULATOR

NEVER REUSE OLD CONNECTORS WHEN

INSTALLING THIS COOKTOP.

WARNING:

Never reuse old flexible

connectors. The use of old flexible connectors

can cause gas leaks and personal injury. Always

use new flexible connectors when installing a gas

appliance.

To reduce the likelihood of gas leaks, apply teflon

tape or a thread compound approved for use with

LP or Natural gases to all threaded connections.

Screw a section of pipe onto

the inlet end of the pressure

regulator and install the

coupling.

3

INSTALL REGULATOR ONTO

BURNER BOX BOTTOM

Screw the regulator

onto the burner

box bottom pipe

connection. Make

sure the top of

the regulator is

facing towards the

cabinet front, easily

accessible through

the cabinet doors.

The regulator may

also be installed

prior to inserting

the cooktop into the cutout if extreme caution is

used to ensure the regulator connection is not

compromised.

4

COMPLETE CONNECTION WITH A

COUPLING

Complete the

connection between

the regulator, pipe

coupling, and

the shut-off valve.

Pressure

Regulator

Pressure

Regulator

Shut-Off

Valve

Coupling

Electrical

Outlet 12s

Below

Countertop

Coupling

Pressure

Regulator

Shut-Off

Valve

Coupling

Electrical

Outlet 12s

Below

Countertop

Advertising
This manual is related to the following products: