GE JGRS06BEJBB - Manual (Page 11)

11
Using the oven.
GEAppliances.com
Automatic Ignition
The oven burner is lit by electric ignition.
To light the burner, do the following:
Touch the pad for the desired function.
Then touch the + or – pads until the desired
temperature is displayed. The burner should
ignite within 60 seconds.
After the oven reaches the selected
temperature, the oven burner cycles off
completely, then on with a full flame to keep
the oven temperature controlled.
Before you begin…
Look at the controls. Be sure you
understand how to set them properly.
Check the oven interior. Look at the racks.
Take a practice run at removing and
replacing them properly to give sure,
sturdy support.
Read over the information and tips that
follow.
Keep this manual handy so you can refer
to it, especially during the first weeks of
using your new oven.
NOTE: You may notice a “burning” or “oily” smell
the first few times you turn your oven on. This
is normal in a new oven and will disappear in a
short time.
Power Outage
The oven burner will not light in the event of an
electrical power outage.
CAUTION:
Do not attempt to light
it manually with a match.
Oven Vent
When the oven is on, heated air moves through
a vent behind the grille.
The vent area could get hot during oven use.
The vent is needed for proper air flow in the
oven and good baking results. Do not block this
vent. Doing so may cause oven failure or fire.
Oven Light
Touch the OVEN LIGHT pad to turn the light on
or off.