AEG LAVAMAT 72330 - Manual (Page 24)

Instructions for use
24
Washing Cycle Ended/Remove Washing
After a washing program has ended, END (EINDE, FIN) lights up on the
program sequence display.
If you selected RINSE HOLD (GEEN CENTR., SANS ESSOR.), the indicator
next to the button START/PAUSE (START/PAUZE, MARCHE/PAUSE)
flashes.
0 1. After a rinse hold, it is first necessary to pump off the water:
– Either press the button START/PAUSE (START/PAUZE, MARCHE/
PAUSE) (water is pumped off and the washing is spun according to
the program which has just run; after the button START/PAUSE
(START/PAUZE, MARCHE/PAUSE) is pressed again, the spin speed can
also still be changed during spinning),
or
– turn the program selector to PUMP (POMPEN, VINDAGE) and press
the button START/PAUSE (START/PAUZE, MARCHE/PAUSE) (water is
pumped off without spinning),
or
– turn the program selector to SPIN (CENTRIFUG., ESSORAGE) or SHORT
SPIN (KORT CENTRIFUG., ESSOR. DELICAT) and press the button
START/PAUSE (START/PAUZE, MARCHE/PAUSE) (water is pumped off
and the washing is spun or gently spun).
The indicator END (EINDE, FIN) lights up after the end of this program
step.
2. Open the filling door.
The filling door can be opened as soon as the indicator DOOR (DEUR,
PORTE) lights up green.
3. Remove the washing.
4. Turn the program selector to OFF (UIT, ARRET).
5. Close the water valve.
6. After washing, pull out the washing detergent drawer slightly so that it
can dry out. Only lean the door against the washing machine so that
the latter can air out.
3 If the display OVER DOSING (OVERDOS., SURDOSAGE)
lights up, too much washing detergent was used in the
washing program just ended. During the next wash, pay
attention to the dosing information of the washing detergent
manufacturer and pay attention to the filling quantity!
Attention! If the washing machine is not used for a long time:
Close the water tap and disconnect the washing machine from the
electricity mains.
OVERDOS.
SURDOSAGE