GE ZIPS360NZ - Manual (Page 8)

8
Temperature
controls
The temperature display shows the actual
temperature of the freezer and fresh food
compartments. The actual temperature will vary
from the set temperature based on factors such
as frequency of door opening, amount of food,
defrost cycling and room temperature.
NOTE:
Frequent door openings or door left open
for periods of time may increase the internal
temperature of the freezer and fresh food
compartments temporarily.
To turn off the cooling system in both the
freezer and fresh food compartments, press
either + pad until both displays show OFF.
To turn the cooling system on, press either
– pad. The preset temperatures of 0°F and 37°F
will appear in the display.
To check the current temperature setting for
the fresh food or freezer compartment, press
the + or – pad once. After 5 seconds, the display
will return to the actual temperature.
To change the temperature settings, press
the + or – pads to desired temperature set point
for fresh food and freezer separately. Allow
24 hours for the refrigerator to reach the
temperature you have set.
Temperature Ranges
Low High
Fresh Food
Freezer
NOTE:
Setting the controls to OFF stops cooling,
but does not shut off electrical power to the
refrigerator.
Changing
display
temperatures
from °F to °C
To change the temperature display between
Fahrenheit and Celsius, press the Temp °C/°F.
Door
alarm
To turn the Door Alarm feature on, press
the pad once. The ACTIVE light will come on.
To turn it off, press the pad again.
When the DOOR ALARM is active, the alarm will
flash and beep if you keep the door open for
more than 2 minutes.
Preset Settings
Allow 24 hours to reach these preset temperatures.
34°F
1°C
–6°F
–21°C
44°F
7°C
+4°F
–16°C
Operating Instructions
Bottom Freezer Refrigerator