Dishwasher installation, Step 23, Step 25 literature – GE ZDT800SSFSS User Manual

Page 14: Step 24 replace toekick, On some models)

Advertising
background image

STEP 23

POSITION INSULATION, PRE-

TOEKICK, AND SOUND

BARRIER

(on some models)

Skip this step if the sound insulation package is not

supplied with the dishwasher.
• Locate the sound insulation package and pre-toekick

packages inside the dishwasher.

• Stand the parts upright as shown.

• Locate the control box.

Push insulation block portion under the dishwasher until it

is beneath the control box.

• Push the panel portion up to the front of the block.

• Tuck the sides of the front panel behind the toekick

attachment screw holes.

• Open door all the way, if the door doesn’t stay fully open,

adjust the insulation panel.

• On models so equipped, position pre-toekick over the

insulation. Align the screw holes with the screw holes on

the legs of the dishwasher.

Dishwasher Installation

STEP 23

POSITION INSULATION, PRE-
TOEKICK, AND SOUND BARRIER
(on some models) (Cont.)

• On models so equipped, remove the masking tape from the

sound barrier and door front. Position the sound barrier

over the insulation.

Sound Barrier

14

Toekick

Panel

(On some

models.)

Insulation

Block

(On some

models.)

Dishwasher

Door

Pre-

Toekick

(On some

models.)

Sound barrier

(On some

models. Part is

already attached

to door.)

Control Box

STEP 25 LITERATURE

• Be sure to leave complete literature package, these Installation

Instructions and product samples and/or coupons with the

consumer.

STEP 24 REPLACE TOEKICK

• Place toekick against the pre-toekick and legs of the

dishwasher.

• Align the toekick with the bottom edge and make sure it is

against the floor.

• Insert and tighten the 2 toekick attachment screws. The

toekick should stay in contact with the floor.

• When reinstalling the toe kick on models with a sound

barrier, ensure that the bottom edge of the rubberized flap
is flush with the floor. Any excess material should be tucked
up behind the outer door. Do not allow excess rubberized
flap to lay on the floor. If any excess is not tucked completely
behind the outer door, it will bunch up between the door and
toe kick and impede proper opening and closing of the door.
This will be noticeable because the door will not stay fully
open and will spring up.

Tip: Reduce sound from under the dishwasher. Make sure
toekick is against floor.

Figure AJ

Attachment

Screws

Toekick

Push the sides of the insulation behind

the toekick attachment screw holes

Figure AF

Figure AG

)LJXUH$+

Advertising
This manual is related to the following products: