GE ZDT800SSFSS - Manual (Page 8)

STEP 9 POSITION WATER LINE AND
+286(:,5,1*
• Position water supply line and house wiring on the
floor of the opening to avoid interference with base of
dishwasher and components under dishwasher.
STEP 10 ,167$//'5$,1+26(
7+528*+&$%,1(7
• Position dishwasher in front of cabinet opening. Insert
drain hose into the hole in cabinet side. If a power cord
is used, guide the end through a separate hole.
Tip: Prevent unnecessary service call charges for fill,
drain or noise concerns.
Position utility lines so they do not interfere with anything
under or behind the dishwasher.
Dishwasher Installation
STEP 6 REMOVE FLOOR PROTECT
• Disconnect leak sensor wire
(on some models).
• Remove 2 screws from front of the
Floor Protect with a ¼” driver.
• Rotate Floor Protect outward and lift
out of the mounting tabs.
• Set aside for use in Step 22.
Floor Protect
Leak Sensor
Figure L
STEP 7 INSTALL 90° ELBOW
• Thread 90° elbow
onto the water valve.
• Do not overtighten
elbow. Water valve
bracket could bend
or water valve fitting
could break.
• Position the end of the
elbow to face the rear
of the dishwasher.
Figure M
Water Valve
Bracket
Fill Hose
Front of dishwasher
STEP 8 ,167$//'5$,1+26(72
DRAIN LOOP
Connect drain loop end to drain hose using the screw
clamp as shown in the figure.
NOTE: The high drain loop on the side of the tub is
designed for better wash performance. Do not remove
from the side of the tub.
Figure N
Figure O
Water
Line
House
Wiring
4" 4"
6" 6"
Power Cord
(If Used)
Insulation
Blanket
Water
Line
Maximum Drain Hose
Length 15'
House
Wiring
Drain
Hose
Figure P
8
90° Elbow
Squeeze connector at top
to release snap feature