GE ZV925SLSS - Manual (Page 17)

17
Installation Instructions
STEP 11 INSTALL LOWER DUCT COVER
• Place rear duct cover onto the hood.
• Place front duct cover onto the hood.
• Secure the duct covers with 6 screws.
Front bottom duct cover section
(snap into place and secure
with 6 screws – 3 per side)
Plan diagram
top view
Front bottom duct
cover sections
STEP 12 INSTALL DUCT COVER TRIM
• Install side brackets to secure the lower duct
tightly against the upper duct.
• Hold lower trim strips (narrow pieces) with hooks
facing down. Place the hooks inside the slots and
slide downward.
• Select the correct size upper trim strips and press
into place.
Upper
trim
strip
Lower
trim strip
Lower
trim
strip
Upper
trim
strip
Side
bracket
,167$//$7,21³9(17('727+(2876,'(
STEP 13 INSTALL METAL FILTER
IMPORTANT: Check to be sure that the main ON/
OFF switch next to the motor is in the ON
position.
• Tip the filter into the left or right side of the
opening. Lift the filter to the opposite side and
into the filter lock.
• To remove the filter, pull the filter lock downward.
Filter lock
STEP 14 FINALIZE INSTALLATION
• Remove all tape and packing material.
• Refer to the Owner’s Manual for operating instructions.