GE ZKD910SFSS - Manual (Page 11)

11
SECURE CUSTOM PANEL
TO METAL MOUNTING PANEL
• Lay the custom panel, appearance side down, on a
clean surface.
• Place the flat side of the metal panel onto the back
side of the custom panel, with the mounting flanges
facing up.
• Align the lamp hole in the panel with the mounting
panel.
• Check top, bottom and side overlap dimensions from
the metal panel to wood panel edge as shown.
3/16"
1/4"
7/32"
1/4" Top
Bottom Align Holes
Handle
Attachment Holes
FOR PANELS LESS
THAN 3/4” THICK
• Separate the custom panel and metal panel.
• Apply a few horizontal beads of adhesive to the metal
panel. Avoid adhesive within 1” of lamp hole area and
outer edges.
FOR 3/4” (OR GREATER)
THICK PANELS
3/4” thick panels may be secured to the metal panel
with screws.
• Use the metal panel as a template. Position the metal
panel over the back side of the custom panel and drill
pilot holes. Drill pilot holes sized to match screws being
used (screws not provided).
CAUTION:
Select screw length carefully to
avoid penetration of the finished side.
INSTALL LAMP JEWEL
Turn the assembly appearance side up.
• Use plastic to wood adhesive to secure the lamp jewel
to the front of the wood panel. On the side with the
bulge, (see illustration) apply a small bead of adhesive
around the outside edge. Place the jewel into the
drilled hole.
Insert
Jewel
Appearance
Side
This Side
Against
Wood
REINSTALL ORIGINAL
HANDLE OR OPTIONAL
CUSTOM HANDLE
A custom handle (not supplied) may be installed.
• Drill pilot holes through the front of the custom panel
and through the metal panel to match the chosen
handle.
NOTE: The handle screws should be installed through
the metal panel, the custom panel and into the custom
or original handle.
INSTALL ASSEMBLED PANEL
TO THE DRAWER
• Install the custom panel assembly to the exposed
drawer front using the original 7 screws.
Back side of Appearance Panel with Support Panel
Installation
STEP 4
STEP 5
STEP 5A
STEP 6
STEP 7
STEP 8
Custom Handle
or Original Handle