Brewer Element Treatment 2130/2140 - Manual (Page 2)

Document 101292 RevA Printed in USA © 2010 2
MODELS 2130 & 2140
For the above models you will receive
two separate cartons: a frame carton,
and an upholstery carton. Inspect both
carefully for shipping incurred damage.
COMPONENT IDENTIFICATION
Perform the following sequence in order when setting up
the table:
- Unpacking
- Assembly
- Leveling the Table
- Installing the Paper Roll
NOTE: Inspect all boxes and contents for damage.
Report any damage to the carrier immediately.
OVERVIEW
COMPONENT IDENTIFICATION MODELS 2130 and 2140 HARDWARE
NOTE: Save all packaging in case re-shipment is re-
quired.
Rubber Mallet 9/16” Open End Wrench
Phillips Screw Driver 7/16” Socket or Wrench
1/4”-20 x 4” Screw A (Qty 1)
1/4”-20 x 2” Screw B (Qty 7)
1/4”-20 x 1 1/4” Screw C (Qty 8)
Cotter Pin (Qty 2)
Bumper (Qty 2)
J-Bolt R (Qty. 2)
3/8” Nut L (Qty. 2)
Washer M (Qty. 2)
10-24 x 1 1/4” Screw D (Qty 2)
Cap (Qty 2)
1/4”-20 x 1” Screw F (Qty 8)
1/4”-20 x 1/2” Screw G (Qty 5)
Clevis Pin (Qty 2)
Snap Rivet (Qty 26)
1/4”-20 Nut H
Allen Wrench (Qty. 1)
(Qty 6)
WARNING
Two or more people should assist in moving the table.
Use proper lifting techniques when lifting. Failure to
do so could result in serious injury!
MODELS 2130 and 2140 TOOLS NEEDED
CAUTION
To avoid damaging the table’s upholstery or
painted surfaces, DO NOT use a knife or any other
sharp object to open the packaging.