Ag Leader GPS 2500 Firmware Update Instructions - Manual (Page 4)

4/21/14 Rev
D
4
8. You will receive a Subscription Accepted message if the code is valid and entered correctly, as
shown in Figure 3
9. Click on the Red X at the upper right hand corner of the program to exit. Make sure to
select Exit and Save.
Setting the Correction Age:
1. This is an optional step and may be necessary for your use.
2. Open and connect the receiver to Pocket Max PC.
3. Select the TMNL button at the bottom of the screen.
4. Enter the following command to set the Correction Age: $JAGE,40 (example is a 40 second
correction age; this number can be adjusted to fit your preference. Less than 40 seconds is not
recommended)
5. You will receive a $> message as a confirmation.
6. Click on the Red X at the upper right hand corner of the program. Make sure to select Exit and Save.
Display Setup/Diagnostics:
Starting in version 3.5 display firmware, the display supports RTK setup and diagnostics for the GPS 2500.
Setup:
A selection is available for RTK differential.