Bell Powersports RevolverEVO Snow - Manual (Page 3)

Face Shield and Inner Shield Removal
1. Use the release levers and remove the stock Revolver shield (Figure 1)
2. Next, actuate the inner shield to the down position (Figure 2)
Figure 2 Figure 1 Figure 4 Figure 3
3. Peel back the rubber face port edging and grab edges of the inner shield (Figure 3)
4. Carefully pull the inner shield directly away from pivot trays. DO NOT PULL SIDEWAYS (Figure 4)
5. Be sure to follow the same procedure for both the left & right sides