Bell Powersports RevolverEVO Snow - Manual (Page 4)

Snow Shield Installation
1. Take the Persimmon Sun Shade Internal Shield and hold by the edges
2. Peel back the rubber face port edging (Figure 5 & 6)
3. Be sure the pivot trays are in the down position
4. The inner shield snap feature must be carefully positioned into the tray and locked into place
5. Be sure to follow the same procedure for both the left & right sides 1. Take the double shield and position it using the Bell shield install alignment markings (Figure 7)
2. Carefully push the shield in until it locks into place (Figure 8)
3. Be sure to follow the same procedure for both the left & right sides
4. Be sure the shield is completely locked into place on both sides
Double Shield/Electric Double Shield Installation
Figure 6 Figure 5
Figure 7 Figure 8