BMR Suspension BK027 User Manual
BMR Suspension For the car
Advertising
Delrin
Rear Subframe Bushings
BK027
Required Tools:
Hydraulic jack and 2 stands (lift optional but recommended)
Wrenches – 18mm, 21mm
Sockets – 10mm, 13mm, 18mm, 21mm
Pry-bar
Rubber Mallet
Sawzall
Installation:
1. Lift vehicle and support with stands under the
rocker jack points as shown in Image 1
below.
2. Remove both rear wheels.
3. Using a 15mm socket, remove the driveshaft
tunnel brace. See Image 2.
4. Using a 15mm socket, loosen the exhaust
clamps at the front of the exhaust.
5. Using a helper, slide the rear muffler mounts
off the mounting dowels (Image 3) and then
pull the entire exhaust assembly rearward and
out of the car.
Continued
Advertising