ADTRAN L768 User Manual

Page 130

Advertising
background image

Glossary

114

Express L768/L1.5 User Manual

61202192L1-1

netmask

A 32-bit bit mask which shows how an Internet address is to be divided into

network, subnet, and host parts. The netmask has ones in the bit positions in

the 32-bit address which are to be used for the network and subnet parts, and

zeros for the host part. The mask should contain at least the standard network

portion (as determined by the address's class), and the subnet field should be

contiguous with the network portion.

non-ISDN line

Any connection from a CPE to a SPCS that is not served by D-Channel signal-

ling.

non-ISDN trunk

Any trunk not served by either SS7 or D-Channel signalling.

NT1

Network Termination 1. A unit that provides physical and electromagnetic

termination of the U-interface 2-wire transmission line, converts between Lay-

er 1 formats used at the U- and T- reference points, and performs some main-

tenance functions.

phase jitter

In telephony, the measurement in degrees out-of-phase that an analog signal

deviates from the reference phase of the main data-carrying signal. Often

caused by alternating current components in a telecommunications network.

point-to-point protocol (PPP)

An implementation of TCP/IP which is intended for transmission using tele-

phone lines. PPP provides router-to-router and host-to-network connections

over both synchronous and asynchronous circuits.

poison routes

Routes which have an infinite metric which to other routers means the net-

work for the route is inaccessible.

PRA

Primary Rate Access. Connects high-capacity CPE, such as PBXs, to the net-

work. In the US, this is composed of twenty-three 64 kbps channels and one

64 kbps D-channel. Also known as Primary Rate Interface (PRI).

RFC1490

Request for Comments document which describes an encapsulation method

for carrying network interconnect traffic over a Frame Relay backbone.

RIP

Routing Information Protocol. A protocol used to exchange routing informa-

tion among a set of computers connected by a LAN. RIP uses hop counts as a

routing metric.

Advertising